PP750 Carbine Barrel with Carbon Fiber Sleeve – Preorder

NOTE: I will usually have to machine these barrels for you after you order as I have been too busy to get some done ahead of time. So your order may be delayed a few days. Please have patience and I’ll get them done and shipped. Thanks! 

Turn your PP750 into a carbine with this longer barrel! These are Diana Stormrider Rifle Barrels threaded for the PP750, so they have M10x1 threads on the end with the factory crown on the m10 threaded version.  You can choose to have it cut and threaded 1/2×20 for a standard airgun muzzle brake or Moderator. The 1/2×20 threaded barrels are cut, crowned and threaded on the lathe so there isn’t any polishing or professional crowning procedures done. M10x1 moderators or 1/2×20 are available for this barrel for US customers only. (choose the Chaser/Stormrider moderator in the parts section for the m10 thread version or choose the M60 moderator with 1/2×20 threads for the 1/2×20 barrel). Muzzle brakes in 1/2×20 and m10x1 are available as well in the airgun parts section for Canadians that can’t have a moderator. Muzzle brake shown in picture is not included. You can buy it here: https://airgunarcheryfun.ca/ags-custom-steel-blued-muzzle-brake-1-2×20-or-m10x1/

Choose from the full length carbon fiber sleeve to replace the stock shroud or choose the end cap opt with cap drilled out to 1/2″ so the existing shroud can be used and a short section of carbon fiber will be added on the part of the barrel that sticks out of the end of the shroud.  (choose the options on the page according to your preference)

For Canadian Residents its important to check your velocity after installation to ensure it remains under 500fps. Even with the long barrel this is still considered a pistol and so must remain under 500fps or will be considered a restricted firearm.